Detailed Product Description
PRODUCT DESCRIPTION
The compound is designed for revitalization – repair, restoration, antiwear protection and increase of service life of power steering booster and other hydraulic equipment parts, and improvement of lubricating properties of hydraulic fluid.
The special two-component formula of the compound allows to achieve the effect of simultaneous restoration of worn-out parts, their protection against wear and enhancement of lubricating properties of hydraulic fluid.
- Restores operating surfaces of parts and compensates for their current wear
- Decreases steering force
- Eliminates pump howl caused by wear
- Increase pumping capacity
- Decrease noise and vibration of the hydraulic system pump
- Improves lubricating properties of hydraulic fluid and tribological characteristics of couplings
- Increase operating precision of the hydraulic steering booster within 30-60 miles after application
- Protects parts against wear by low levels of hydraulic fluid
APPLICATION
Introduce the content of the syringe* into the fluid, which is warmed up to the operating temperature, in the tank of a power steering booster. Start the engine and provide its idle operation for 2-3 minutes. Then turn the steering wheel for 5 minutes with the engine turned on. Drive a car as you normally do. The treatment is considered complete after the mechanism has been in operation for 50 hours or after 950 miles of run.
*1. The temperature of the compound before application should not be lower than +20…+25 0C.
2. It is recommended to preliminary dissolve the content of the syringe in a small amount (about 50ml) of used hydraulic fluid.
3. If the fluid in the tank of a power steering pump is contaminated (opaque or changed its initial colour etc.) it’s recommended to change hydraulic fluid before application.
DOSAGE
30 ml of the product is enough for a hydraulic system with a capacity of 3-5 l. If hydraulic fluid exceeds 5 liters dosage should be increased at the rate of 30 ml for every 5 l of oil.
PACK
Syringe 30 ml XA 42016
